3-Valve Double Block & Bleed, Hard Seat Needle Valves-NOSHOK 3070 Series

Noshok 3070 Series 3-Valve Double Block & Bleed, Hard Seat Needle Valves

NOSHOK 3070-MFS 1/2 NPT, Male x Female, 316 SS, 3-Valve Double Block & Bleed, Hard Seat valve

 

• Combines isolating and venting in a single valve, eliminating the need for
  tubing and fittings
• Block valve isolates the downstream process fluids, and the bleed valve
  exhausts upstream fluids enabling instruments to be removed without
  disturbing the permanent piping installation on the bottom
• The 1/4″ NPT vent plug is located 90° to the left and may be removed and replaced with exhaust piping to direct the fluids to a safe location
• 100% helium leak tested to 1 x 10^-4 ml/s for guaranteed performance
  and reliability
• 10,000 psi hard seat pressure rating @ 200 °F
• Blow-out proof stem provides a secondary stem seal in the full open
  position
• FKM o-ring seal and PTFE back-up ring below the stem threads to protect from corrosion and galling; PTFE or Grafoil^® packing optional
• All stems are 316 stainless steel
• All stem threads are rolled for strength and ease of operation
• One-piece bonnet with a metal-to-metal seal to the valve body below the bonnet threads
• Slotted spring pin to prevent accidental loosening
• Vinyl dust cap for bonnet and stem (non-packing)

To meet all of your specific application requirements, the following additional options are available for these needle valves. To order all or any of these options, simply add them to the part number as shown in the diagram below.
NOTE 1: The example shown includes ALL possible additional options. Please include ONLY the options required for your application when building your part number. (EXAMPLE: 3070-FFC-HL5)
NOTE 2: When a packing option is selected, an o-ring option is NOT available.

ORDERING INFORMATION – Additional Options

 

† If a packing option is chosen, maximum pressure rating is 6,000 psi. Refer to the “Pressure vs Temperature: Packing Style with Compatible Fluid” chart.

*   Other o-ring materials available on request.

Please note that the standard o-ring in all the NOSHOK valves is FKM and the standard handles are block “T” handles (HL2) and bleed 1-3/8″ mini “T” handle (HL7).

The handle material will always match the material of the valve, unless otherwise specified. For example, the “T” handle (HL2) on the 3070-FFC will be steel. When only the standard configuration is needed, no additional designations are necessary. Please consult the factory for special application requests.